1995 Eurovan Camper TDI 5-spd For Sale

This is a one owner west-coast, rust-free/accident free 95 EVC that we purchased this past winter as a spec project and we are finally getting around to lining up a buyer to expedite the completion of the project.  The original owner was a small town doctor here in Oregon who used this van very lovingly during his time with it.  Van is registered in Oregon and will be titled as a diesel and registrable in all 50-states.

As part of this sale the following upgrades, basic service and preventative maintenance are being performed ($3k+ value):

• new 15" tires on VW alloy rims (16" wheel/tire package $750 extra)
• new 8' Fiamma awning
• new OE VW mudflaps front/rear
• new upper/lwr ball joints
• CV joint service
• Bilstein shocks front/rear
• lift kit and level
• all camper equipment serviced and operational
• poptop seals replaced

Engine/transmission options:

Package #1:  Used low-mileage (75k miles) euro-spec 4-cyl AFN 1.9l TDI engine w/ new VNT-17 turbo, and stage IV tune & injectors (150hp, 320ft/lbs torque), new eng seals, timing belt, water pump, T-stat, etc; re-built/re-geared 5-spd trans. with comparable EWB gearing (4.23 R&P, found behind the 150hp T4s in Europe).  30-35 MPG average in this EVC.
$29,500

Package #2:  Used low-mileage (120k miles) euro-spec 5-cyl TDI engine with stock injectors/tune, new eng seals, timing belt, water pump, T-stat, etc; used 02G 5-spd transmission with stock gearing.  ~25-30 MPG estimate in this EVC.
$33,500  (please note this engine/trans option may not be available as we have one customer possibly selecting this engine for his conversion and he has first dibs)

Package #3:  Completely rebuilt 4-cyl AHU 1.9l TDI engine w/ new K03/K04 hyrbrid turbo and stage IV tune & injectors (140hp, 300ft/lbs torque), new eng seals, timing belt, water pump, T-stat, etc; re-built/re-geared 5-spd trans. with comparable EWB gearing (4.23 R&P, found behind the 150hp T4s in Europe).   30-35 MPG average in this EVC.
$35,000  (please note this option will take an additional 2-4 wks to complete as we need to build and engine up for it)


Serious inquiries only! Please contact me directly if you are interested: justin at greaseworks dot com


Please note: These pics are of the van as it currently sits.  The work outlined above has yet to be completed, and will be commenced once we have a committed buyer, an agreed upon engine/trans package and a 50% deposit on the order.

IP input shaft seal removal tool